5.2 Eth
The Eth object provides access to Ethernet network
The Eth object corresponds to the Interface MIB2 described in RFC
5.2.1 Eth Commands
Note:
The Eth object is always followed by one or more name strings that
In the commands below, this string is represented as
For more details on this convention, see
Objects.
5.2.1.1 Set
Assign and modify device parameters using the Set command:
set eth <eth-list>
[eth-
[auto-
neg {enabled | disabled}]
[lo
[alarm-
propagation {disabled | backward | forward | both directions}
5.2.1.2 Show
Display device parameters using the Show command:
show eth [{<eth-
[{info | description | mtu | mac
| last-
change | name | alias | eth
| auto-
| alarm
The Eth object provides access to Ethernet network
-
related device parameters.
The Eth object corresponds to the Interface MIB2 described in RFC
-2863.
The Eth object is always followed by one or more name strings that
ts or devices to be acted upon.
In the commands below, this string is represented as
<eth-
For more details on this convention, see
Section 4.9.6.,
Assign and modify device parameters using the Set command:
-type-set>]
neg {enabled | disabled}]
-mode { disabled | external | internal}]
-timeout <integer>]
propagation {disabled | backward | forward | both directions}
Display device parameters using the Show command:
[{info | description | mtu | mac
-
addr | admin | operational
change | name | alias | eth
-type | eth-act-
-mode | loopback-
propagation}]]
Page 99
related device parameters.
The Eth object is always followed by one or more name strings that
.
propagation {disabled | backward | forward | both directions}
addr | admin | operational
4Gon www.4Gon.co.uk
[email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
Comments to this Manuals